New 3D printed V12 engine works | EngineDIY

The engine is an XLA high-precision 3D printed resin model. It is a non-metallic product. The parts are relatively small and delicate, fragile and easily damaged. Be careful during assembly and use. This V12 engine is a KIT parts version and requires DIY assembly and construction.

Full simulation RC engine: from any angle, it has simulation significance. Simulation design based on real V12 gas engine structural principles. Real drive structure of pulley windings, supercharger, generator, air conditioning compressor, power steering pump, water pump, etc. Complete output flywheel disc as well as layered cylinder head, cylinder head cover, etc. Even the intake manifold with spiral far and near valve simulation structure. Fully simulated oil pan structure and power supply drive board plug interface.

Dynamic simulation: The V12 engine model can be energized to simulate operation (power supply not included). At the same time, we considered the stability and reliability of operation and implemented a full bearing structure of the driving part in a mini space.
Build this kit through DIY assembly to restore the structure and principles of the V12 engine and exercise your hand-eye coordination. It can be powered and simulated as a stand-alone unit.

V12 engine model parts list:

1.Cylinder

2.Cylinder lower shell

3.Crankshaft

4.Connecting Rod/Connecting Rod Mounting Block

5.Crankshaft mounting block

6.Pistons

7.Cylinder head

8.Camshaft

9.Camshaft case cover

10.Lighter

11.Intake and exhaust valve plugs

12.Air intake box

13.Injector oil passage

14.Air intake filter box

15.Intake and exhaust pump body

16.Intake pipe

17.Exhaust pipe

18.Spark plug

19.Flywheel

20.Motor cover

21.Main driven wheel

22.Cylinder side cover

23.Hot air cover

24.Windwheel

25.

26.Gear

27.Base