Autumn Deals: Get Extra 10% Off with Coupon Code:2024
Join Our FacebookGroup & Get Extra Discount!
Build Your Own MOC Engine Bricks & Save Up to $200 OFF!
Autumn Deals: Get Extra 10% Off with Coupon Code:2024
Join Our FacebookGroup & Get Extra Discount!
Build Your Own MOC Engine Bricks & Save Up to $200 OFF!
DLE Engines DLE 30CC Gas RC Aircraft Engine for RC Plane with Electronic Ignition and Mufflers
This DLE Engines DLE-30cc gas rc airplane engines is a gas rc plane engine. The gas rc engine is electronically ignited, comes with mufflers. Easy to get start. Besides, this rc plane engine is protected by a 2-year limited warranty.
* DLE 30CC Gas Engine
* spark plug
* four standoffs
* muffler
* gasket
* two 5x20mm muffler bolts
* four 5x60mm mounting bolts
* instruction manual
SPECIFICATIONS
Output Power: 3.7 HP at 8,500 RPM
Idle Speed: 1,600 RPM
RPM Range: 1,600-8,500
Static Thrust: 8.5kg Pulling Force/100 meters altitude 7.5kg Pulling Force/1,800 meters altitude
Displacement: 1.86cu in (30.5cc)
Bore: 1.42" (36mm)
Stroke: 1.18" (30mm)
Compression Ratio: 7.6:1
Crankshaft Thread: 5mm
Weight: Engine, 2lbs (910g); Muffler, 2.1oz (60g); Ignition, 4.2oz (120g)
Gasoline/Oil Mixture: 30:1
Gasoline Octane Rating: 87
Recommended Propellers: 18x8 for break-in, 18x10, 19x8, 20x8
Spark Plug: CM6 Carburetor Adjustments;
Low Speed Needle: 1.5 turns out as a starting point, adjust for a smooth idle and a reliable transition to high throttle
High Speed Needle: 1.5-2 turns out from closed, adjust needle to peak RPM, if engine slows or dies at full throttle, the high-speed mixture is likely too lean
Distance Between Mounting Hole Centers Same Side: 2.1" (54mm)
Distance Between Mounting Hole Centers Opposite Side: 2.7" (70mm)
Height from bottom/Crankcase to top of Cylinder Head: 5.4" (138mm)
Width of Cylinder Head: 2.5" (65mm)
Distance Between Muffler Mounting Hole Centers: 1.3" (34mm)
REQUIREMENTS
* Gasoline with at least 87 octane rating
* 2-cycle oil, mix ratio for this engine is 30 parts gas to one part oil and must be followed exactly for warranty consideration and optimum performance
* 4.8 - 6V NiMH/NiCd, or 6.6V LiFe or 7.4V LiPo battery for ignition (separate receiver style pack can be used)
NOTE : 1st version ignition is marked 'A-01' on the label and requires a regulator if using 2S LiPo/LiFe battery. If ignition module is the A-02 model it has a built-in voltage regulator. Model A-02 designation is located above the word "Ignition" on top of the case**
FEATURES
* Two sealed bearings on crankshaft-simple design for lighter weight
* Aluminum alloy crankcase
* Rear mounted pumper carburetor ensures easier installation and smooth idling and dependable fuel flow during flights
* Fully automatic electronic ignition Ignition Sensor available separately
Be the First to See Our New Products and Special Offers.
Copyright © 2024 EngineDIY.